GE GFD48 Manuel D'utilisation Et Instructions D'installation page 10

Control settings.
14
15
16
17
18
19
10
Light
(on some models)
Press the button to turn on the light in the
dryer.
Press the button again to turn the light off.
Volume
This button has two functions:
To change the loudness of the end of cycle
signal, press the button as many times as
needed to reach the desired volume. There are
four sound levels including OFF.
Lock Control
You can lock the controls to prevent any
selections from being made. Or you can lock
or unlock the controls after you have started a
cycle.
Children cannot accidentally start the dryer by
touching buttons with this option selected.
To lock the dryer, press and hold the Lock
Control button for 3 seconds.
eMonitor
(on some models)
The eMonitor lights display the relative energy
use of your selected cycle and options. They are
provided as an energy guide and range from
Good (1 light) to Better (5 lights). Cycle (time),
dryness level, temperature, and additional
tumble options can increase or decrease your
energy efficiency. Some cycles will not provide
a display.
Clean Filter Message
This message represents only a reminder and
does not always appear when the filter needs
cleaning. The filter should be cleaned after every
drying cycle is complete.
Display
Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
This only controls the light when the door is
shut.
NOTE: The light will turn off by itself after one
minute when the door is shut.
To turn the button sounds ON/OFF, press
and hold the button for 3 seconds (on some
models).
To unlock the dryer controls, press and hold the
Lock Control button for 3 seconds.
A sound is made to indicate the lock/unlock
status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE: The Power button can still be used when
the machine is locked.
This message will disappear after the Start/
Pause button is pressed. Even though you may
have already cleaned the filter (before or after the
Power button has been pressed), the "Clean Filter"
message will still be displayed until the Start/
Pause button is activated.
Then lights will "race" in the display. This
means the dryer is continuously monitoring
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the dryer
will calculate and display the approximate time
remaining.