GE GFD48 Manuel D'utilisation Et Instructions D'installation page 43

Before you call for service...
Problem
Time Remaining The estimated time may change
jumped to a when a smaller load than usual
lower number is drying
Cannot make a The dryness Level, Temp or
selection and the option that you are trying to
dryer beeps twice select is incompatible with the
chosen dry cycle
Dryer is running The Ext Tumble option was
but 00 is chosen
displayed in Time
Remaining
Clean Lint Filter Power button was activated
(message)
Dryer doesn't Fuse is blown/circuit breaker is
heat tripped; the dryer may tumble
but not heat
Gas service is off (gas models
only)
LP gas supply tank is empty
or there has been a utility
interruption of natural gas (gas
models only)
Inconsistent Type of heat
drying times
Type of load and drying
conditions
Clothes are still The door was opened mid-cycle.
wet and dryer The load was then removed
shut off after a from the dryer and a new load
short time put in without selecting a new
cycle
Small load
Load was already dry except for
collars and waistbands
Dryer is not level
Clothes are Overdrying
wrinkled
Letting items sit in dryer after
cycle ends
Overloading
Possible Causes
This is normal.
This is normal.
This is normal. During extended tumbling, the time remaining is not
displayed. The extended tumbling option lasts approximately 60 minutes.
Press Start/Pause to begin a dry cycle and the message will disappear.
Check the building's fuse/circuit breaker box and replace both fuses or
reset both breakers. Your dryer may tumble if only one fuse is blown or one
breaker tripped.
Make sure gas shutoff at dryer and main shutoff are fully open.
Refill or replace tank. Dryer should heat when utility service is restored.
Drying time will vary according to the type of heat used. If you recently
changed from an electric to a gas (natural or LP) dryer, or vice versa, the
drying time could be different.
The load size, types of fabric, wetness of clothes and the length and
condition of the exhaust system will affect drying times.
A dry cycle must be reselected each time a new load is put in.
When drying 3 items or less, choose Speed Dry or Time Dry.
Choose Speed Dry or Time Dry to dry damp collars and waistbands. In the
future, when drying a load with collars and waistbands, choose More Dry.
Move dryer to an even floor space or adjust leveling legs as necessary until
even.
Select a shorter drying time.
Remove items while they still hold a slight amount of moisture. Select a
Less Dry or Damp setting.
Remove items when cycle ends and fold or hang immediately, or use the
Ext Tumble option.
Separate large loads into smaller ones.
What To Do
43