GE GFD48 Manuel D'utilisation Et Instructions D'installation page 33

REVERSING THE DOOR SWING (if desired)
IMPORTANT NOTES
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid
using them in the wrong places.
• Provide a non-scratching work surface for
the doors.
• Normal completion time to reverse the door swing
is 30–60 minutes.
TOOLS YOU WILL NEED
#2 Phillips-head screwdriver
DOOR PARTS
2 - #8 x 1/2" Screws
(striker plate)
10 - #8 x 7/8" Screws
(door assembly)
2 - Panel Plugs 1 - Door Striker
(on some models) (on some models)
BEFORE YOU START
Unplug the dryer from its electrical outlet.
Installation Instructions
T-25 torx driver
6 - #8 x 1/2" Screws 2 - #8 x 1/2" Screws
(hinge assembly and
handle spacer)
1 - Door Mask 1 - Chrome Door Cover
Assembly
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges
to switch them back to the right side, follow these
same instructions and reverse all references
to the left and right.
2 - #10 x 5/8" Screws
(door mask)
(hinge)
1 - Handle Spacer
(on some models)
33
1/4" nut driver
2 - #10 x 5/8" Screws
(panel plug)
1 - Handle 1 - Inner Door
Spacer/Latch Assembly
Assembly
(on some models)
1 - #8 x 3/8" Screws
(hinge pin)
1 - Door Plug
(on some models)