GE GFD48 Manuel D'utilisation Et Instructions D'installation page 45

Before you call for service...
Problem
Small amount of water
on floor in front of dryer
Water on floor in back of
dryer
Dryer makes water
noises
Water drips from door
when opened after a
Steam Cycle
Cannot see steam at
beginning of cycle
Cannot see steam at any
time during cycle
Garments still wrinkled
after steam cycle
Dryer continues to
tumble after display says
Complete
Possible Causes
Inadequate load size for steam
cycle selected, excess steam
condenses inside cabinet and
leaks out
Loose water hose connection to
valve
Hose missing rubber washer at
connection with valve
Water valve is open filling
steam generator
Steam generator is dispensing
steam into drum
Steam condenses on inner door
Steam released at different
times in the cycle
The steam nozzle might be
clogged with debris from your
water supply
Too many garments
Ext Tumble was selected
What To Do
If using the Steam Dewrinkle cycle, manually reduce the cycle
time. If using the Steam Refresh cycle, add more garments to
the load.
Tighten connection.
Install rubber washer provided with hose.
This is normal.
This is normal.
This is normal.
This is normal.
Call GE Appliances at 800.GE.CARES to order nozzle
replacement kit WE25M71 or to request a technician to replace
this for you.
Load fewer garments; manually increase time.
Ensure Ext Tumble option is not selected. For the Steam
Refresh cycle, Ext Tumble will automatically be turned on and
cannot be turned off.
45