Publicité
Les langues disponibles
Les langues disponibles
You may reactivate reception by pressing and holding the
DOWN-/
symbol
in the clock field
You also have the option to set the time manually. For more details
please refer to section Basic settings.
Mounting the temperature station and / or the outdoor
sensor on a wall:
Note: You will require an electric drill and a cross head screwdriver
for this step.
CAUTION! DANGER TO LIFE, RISK OF INJURY AND
MATERIAL DAMAGE! Read the operating and safety instructions
for your drill carefully.
DANGER TO LIFE! Take care that you do not hit electricity, gas
or water lines when you drill into the wall. If necessary, check
with a pipe and cable detector before drilling.
Note: Before mounting the temperature station, please fall back the
stand
from back side.
6
Mark the position of the hole (Ø approx. 8 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a cross head screwdriver, screw the screw
Hang the temperature station or outdoor sensor by placing the
hanging slot
Note: Ensure that the outdoor sensor shouldn't be immersed into water
and not contact with direct sunlight. Electronic devices may adversely
affect the wireless signal reception.
button
for three seconds until an radio tower
9
24
into the drilled hole.
33
,
to the according screw.
4
19
becomes animated.
into the dowel.
32
GB/IE/NI
15
Publicité
