Rotel U981EU1 Mode D'emploi page 77

garment over, then first use the super steam (press the steam button), and then iron
it until it is completely dry.
o
Tucked sleeves (puffed sleeves): Place the iron in a vertical position. Hang the tucked
sleeve at its seam over the tip of the iron. Press the steam button until the sleeve is
wrinkle-free.
o
Never hold your other hand in front of the appliance, as the steam emitted is very
hot!
o
How to iron trousers: Position the trouser leg onto the ironing board. Iron in a crease
line. Lift the appliance when you reach the seams and steam them. Vertically steam
the upper part.
o
How to iron hung clothing: Hang the item of clothing on a clothes hanger, making
sure that it hangs freely (no wall or the like behind it). Use one hand to hold the part
you are going to iron so that the garment cannot swing back and forth. The soleplate
must make complete contact with the material. Now press the steam button until the
garment is wrinkle-free.
• AFTER IRONING
o
COMPLETELY EMPTY the water tank after EACH use!
o
To avoid limescale build up, empty the boiler after each use. Prior to emptying the
appliance, turn it off and pull the power plug out of the socket.
o
Set the switch (7) to "0."
o
Pull the power plug out of the socket.
o
Press the steam button (4) to release the pressure.
o
Caution! Let the iron cool down (approx. 2 hrs).
o
Unscrew the safety cap (1) using the cap screw (3), turn the iron upside down to
empty the water remaining in the boiler (Fig. E). Proceed carefully, because the water
is boiling hot. This simple procedure will likewise help to keep the inside of the boiler
clean
o
When you have finished ironing, never completely tighten the safety cap (1), but ra-
ther close it with 3-4 turns.
o
Turn the steam regulator (2) counter-clockwise as far as it will go.
• CLEANING AND MAINTENANCE
o
Caution! Before you clean your iron, pull the power plug out of the socket and let the
iron cool down.
o
Never immerse the appliance in water or other liquids. Regularly check the power
cord for damage before using your iron. Should you detect any damage, take it to
your nearest customer service and have it replaced by a qualified specialist.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
77