BEHA UNITEST Telaris 0100 Mode D'emploi page 39

Measurement Range Message
RCD
123Ω
53V UL:50V
RCD
UL:50V
ZL, IPSC
RCD ---
UL:50V
ZL, IPSC
RCD
ZL, IPSC
RCD
ZL, IPSC
RCD
All functions
All functions "M"
All functions
All functions
---
All functions
-
All functions
UB>UL
UB>UL
UB>UL
is blinking
Display Indications
Cause
Contact voltage has exceeded pre-
set limit, measurement
interrupted.
Contact voltage has exceeded pre-
set limit during the socket test.
The contact voltage exceeded the
pre-set limit already during the
socket test. Measurement therefore not carried out
TELARIS 0100 is overheated,
therefore no further
measurements can be carried out.
Socket incorrectly connected, or
RCD has tripped.
Insert plug after turning it by
180°C.
reference to limit excess within
one measurement variable.
Minimum one measurement result
has been stored in memory.
Batteries are virtually empty and
have to be replaced.
Measurement results no longer
comply with the specifications.
Batteries are empty. No funktion of the Telaris
TELARIS 0100 is ready for measurement.
TELARIS 0100 is active (active measurement).
39