Energy Management; Appropriate Usage; Maintenance; Cleaning - BEHA UNITEST Telaris 0100 Mode D'emploi

Maintenance / Battery Replacement

9.0 Energy Management

Approximately 5 minutes after the last key operation,
the instrument switches off automatically (auto-
power-off). To switch the instrument on again, turn
the rotary switch from the „OFF" position to the de-
sired function.

10.0 Appropriate Usage

The instrument may only be used under those con-
ditions and for those purposes for which it was built.
For this reason, in particular the safety references
(chapter 3.0),as well as the technical data including
environmental conditions (chapter 15.0) and the
usage in dry environments must be followed at all
times.
When modifying or changing the instrument, the
operational safety is no longer guaranteed.
The instrument may only be opened by an au-
thorised service technician, e.g. for fuse re-
placement.

11.0 Maintenance

When using the instrument in compliance with the
instruction manual, no special maintenance is re-
quired.
Should operational problems occur during daily use,
our Hotline Support (phone 0049(0)7684/8009-29)
will be at your disposal, free of charge.
For any queries regarding the instrument, please al-
ways quote product designation and serial number,
both marked on the type shield label on the instru-
ment rear.
If functional errors occur after expiration of warran-
ty, our after sales service will repair your instrument
without delay.
40

11.1 Cleaning

If the instrument is dirty after daily usage, it is advised
to clean it by using a humid cloth and a mild house-
hold detergent.
Prior to cleaning, ensure that the instrument is
switched off and disconnected from external
voltage supply and any other instruments con-
nected (such as EUT, control instruments, etc.).
Never use acid detergents or dissolvants for
cleaning.

12.0 Battery Replacement

Prior to battery replacement, disconnect the in-
strument from the connected measurement circuits.
" If the battery symbol (8) appears in the display,
proceed with battery replacement.
" Switch off the instrument via the rotary switch.
" Loosen the screws on the instrument rear.
" Lift the battery case cover (by slightly hitting the
instrument in the palm of your hand).
" Remove the discharged batteries.
" Insert new batteries and ensure there is correct
polarity.
Only use batteries in compliance with the speci-
fications in the technical data section 1,5V
Mignon Typ IEC LR6 (size AA).
" Replace the battery case cover and retighten the
screws.
" The instrument is now ready for further mea-
surements.