Blomberg BGR 24100SS Manuel D'utilisation page 22

Butan/propan
Natural gas
Fasten the
screw
until the end
Loosen the
screw
1/2 round
tbo
B CAUTION:
If the gas type of the unit is changed,
then the rating plate that shows the
gas type of the unit must also be
changed.
The California Safe Drinking Water and
Toxic Enforcement Act requires the
Governor of California to publish a list of
substances known to the State of Cali¬
fornia to cause cancer, birth defects, or
other reproductive harm, and requires
businesses to warn of potential exposure
to such substances.
A
IMPORTANT:
This product
contains a chemical known to the
State of California to cause cancer,
birth defects, or other reproductive
harm.
This appliance can cause low-level ex¬
posure to some of the substances listed,
including benzene, formaldehyde, car-bon
monoxide, and toluene.
Connection to the main suppiy
A
IMPORTANT:
Electrical
installation should comply with
national and local codes.
A
IMPORTANT:
This appliance
must be groundedi
A
WARNING:
Avoid fire hazard or
electrical shock. Do not use an adapter
plug, an extension cord, or remove
grounding prong from elecfrical power
cord. Failure to follow this warning can
cause serious injury, fire or death.
This appliance is equipped with a
3-prong grounding plug for your
protection against shock hazard and
should be plugged directly into a properly
grounded receptacle. DO NOT cut or
remove the grounding prong from this
plug.
For personal safety, the range must be
properly grounded. For maximum safety,
the power cord must be plugged into an
electrical outlet that is correctly polarized
and properly grounded.
If a 2-prong wall receptacle is the
only available outlet, it is the personal
responsibility of the consumer to have
it replaced with a properly grounded
3-prong wall receptacle installed by a
qualified electrician.
A
WARNING:
Do not ground to a
gas pipe.
Our company shall not held responsible
for any damage caused by using the
appliance without grounded receptacle.
The wiring diagram covering the control
circuit is located inside the lower panel,
below the oven door panels.
The main supply data must correspond
to the data specified on the rating plate
22