Publicité
Les langues disponibles
Les langues disponibles
is lit, inspect the flame. See below flame fig¬
ures for proper flame characteristics. If the
flame burns completely or mostly yellow,
adjust the broil burner air shutter. See below
flame figures for details.
Replace oven bottom cover. Slide cover
into place and replace two rear thumb
screws.
Flame Characteristics
Yellow Flames:
Further adjustment is required.
Yellow Tips on Outer Cones
Normal for LP Gas.
Soft Blue Flames:
Normal for Natural Gas.
If the flame is completely or mostly yellow,
verify that the regulator is set for the correct
fuel. After adjustment, retest.
Some yellow streaking is normal during the
initial start-up. Allow unit to operate 4-5
minutes and re-evaluate before making
adjustments.
Call Service if;
1. Any of the burners do not light.
2. The broil burner or bake burner flame
goes out before reaches 350 F.
3. Any of the burners continue to burn yel¬
low.
conversion."
/K
CAUTION:
Risk of explosion!
Before starting any work on the gas
installation, please shut off the gas supply.
In order to change your appliance's gas
type, change all injectors and make flame
adjustment for all valves at reduced flow
rate position.
Exchange injector for the burners
1. Take off burner cap and burner body.
2.
Unscrew injectors.
3.
Fit new injectors.
4.
Check all connections for secure
fitting and tightness.
□ NOTICE
New injectors have their position marked
on their packing or injector table on
page 36 can be referred to.
1
2
3
4
1
Flame failure device
2
Sparking plug
3
Injector
4
Burner
If flame adjustment is necessary, continue
to next page. Otherwise, installation is com¬
plete at this point
Gas conversion
"This appliance can be used with LP
gas ans Natural gas. It is shipped from
the factory adjusted for use with natural
gas. Conversion orifices are located in
conversion kit. Follow the instructions
packed with the orifices for gas
A
CAUTION:
Unless there is an abnormal condition, do
not attempt to remove the gas burner
taps. You must call an Authorised
service agent if it is necessary to
change the taps.
Reduced gas flow rate setting for
hob taps
1.
Ignite the burner that is to be adjusted
and turn the knob to the reduced
position.
Publicité
