Blomberg BGR 24100SS Manuel D'utilisation page 17

Apply pipe joint compound orTeflon* tape
appropriate * for use with LP gas and
Natural gas around all male pipe threads to
prevent leaks.
If not already present, install gas shut off
valve in an easily accessible location. Make
sure all users know where and how to shut
off the gas supply to the range.
NOTE:
The installer should inform the
consumer of the location of the gas shut¬
off valve. Flexible Connector Method (see
Figure 4)
1. Install male 1/2" flare adaptor at the 1/2"
NPT internal thread of the range inlet. Use a
backup wrench on the elbow fitting to avoid
damage.
2. Install male 1/2" or 3/4" flare union
adapter on the NPT internal thread, of the
manual shut-off valve.
3. Connect flexible metal appliance connec¬
tor.
4. Make sure circuit breaker is off and then
plug range cord in to electrical outlet
5. Push range back into position insur¬
ing that range leg slides under the anti-tip
bracket. The range will sit 3/4" away from
the wall when properly installed.
NOTE:
Be careful not to crimp flexible con¬
nector!
6. Carefully tip range forward to insure that
anti-tip bracket engages and prevents tip-
over.
Rigid Pipe Method
(see Figure 4.)
The configuration of the rigid pipe connec¬
tion will vary depending on the location
of the gas pipe stub. Refer to Figure 4 for
details.
1. Make sure circuit breaker is off and then
plug range cord in to electrical outlet
2. Push range back into position insur¬
ing that range leg slides under the anti-tip
bracket. The range will sit 3/4" away from
the wall when properly installed.
3. Carefully tip range forward to insure that
anti-tip bracket engages and prevents tip-
over.
4. Connect pipe to range at union. Access
the connection through the access panel
behind the warming drawer.
NOTE:
Be careful not to apply pressure to
warming drawer element during rigid pipe
installation.
Proceed to "Test for Gas Leaks"