ISE SY-1002 Manuel D'utilisation page 33

TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine
willturn off automatically to prevent any injuries to the user and to prevent damage to the
machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly,please run the
self-checking analyse (please refer to Self-Checking) to distinguish what type of error
problem the machine is encountering.
Before attempting any work on the treadmill, ensure that the power is off and the plug is
removed from the power point.
Do not use extension leads as it may lead to power decrease and failure.
1. Alarm signals
E01 No feedback from speed sensor
1.Check the distance from speed sensor to the magnetic of roller,and adjust it with in
3mm.
2.change speed sensor
E02 Over voltage protection of motor
1.Make the machine self-checking again
2.Change controller
EN
E03 Over current protection
1.Clean the dust between running board and belt, then put some oil
2.If the running belt wear seriously,please change the running belt
E04 Motor open circuit
1.Check the check the connect wire of motor ,if the connect wire loose,please connect it
again.
2.The motor carbon brush wear, replace carbon brush or motor
E05 EEPROM damage or access problems change the controller board
E06 Communication error
1.Check the connect wire between computer and controller board, if it loose or bro-
ken,please connect it again or change it
2.change the incline motor
E07 incline error when self-checking:
1.check the connect wire between incline motor and controller board if it get loose orbro-
ken, please connect it again or change it
2.Change the incline motor
E08 speed error when self-checking
1.check the distance from speed sensor to the magnetic of roller and adjust it within 3mm
2.Change the speed sensor
13