ISE SY-1002 Manuel D'utilisation page 31

Les langues disponibles

Reasonable cleaning/lubricating should be made to extend the life time of this unit. Perfor-

mance is maximized when the belt and mat are kept as clean as possible.

WARNING: THE MAT/DECK FRICTION MAY PLAY A MAJOR ROLE IN THE FUNCTION AND

LIFE OF YOUR TREADMILL AND THAT IS WHY WE RECOMMEND YOU CONSTANTLY LUBRI-

CATE THIS FRICTION POINT TO PROLONG THE USEFUL LIFEOF YOUR TREADMILL.FAILING

TO DO THIS MAY VOID YOUR WARRANTY.

WARNING: UNPLUG POWER CORD BEFORE MAINTENANCE.

WARNING: STOP TREADMILL BEFORE FOLDING.

1. General Cleaning

Use a soft, damp cloth to wipe the edge of the belt and the area between the belt

edgeand frame.A mild soap and water solution along with a nylon scrub brush will clean

the topof the textured belt.This task should be done once a month.Allow to dry before

using.

On a monthly basis,vacuum underneath your treadmill to prevent dust build up.Once

ayear, you should remove the black motor shield and vacuum out dirt that may accumu-

late.

2. General Care

Check parts for wear before use.

Always replace the mat if worn and any other defective parts.

If in doubt do not use the treadmill and contact our helpline.

TAKE CARE TO PROTECT CARPETS AND FLOOR in case of leakages,This product is a

ma-chine that contains moving parts which have been greased / lubricated and could leak.

3. Belt/Deck/Roller Lubrication

The mat/deck friction may play a major role in the function and life of your treadmill

andthat is why we recommend you constantly lubricate this friction point to prolong the

usefullife of your treadmill.

You should apply the lubrication after approximately the first 40 hours of operation.

We recommendlubrication of the deck according to the following timetable:

Light use (less that 3 hours per week) every 6 months

Medium use (3-5 hours a week) every 3 months

Heavy use (more than 5 hours per week) every 6-8 weeks.

See below procedures for lubricating:

1.Use a soft, dry cloth to wipe the area between the belt and deck.

2.Spread lubricant onto the inside surface of belt and deck evenly (make sure the ma-

chineis turned off and power is disconnected).

3.Periodically lubricate the front and rear rollers to keep them at there peak perfor-

mance.If the treadmill belt/deck/roller is kept reasonably clean it is possible to expect

over 1200hours before additional re-lubing is necessary.

MAINTENANCE