ISE SY-1002 Manuel D'utilisation page 22

19.The pulse sensor is not a medical device.Various factors, including your movement,may affect
the accuracy of heart rate readings.The pulse sensor is intended only as anexercise aid in determin-
ing heart rate trends in general.
20.Do not attempt to raise, lower, or move the treadmill until it is properly assembled.Youmust be
able to safely lift 45 lbs.(20 kg) to raise, lower, or move the treadmill.
21.When folding or moving the treadmill, make sure that the storage latch is holding theframe
securely in the storage position.
22.Do not change the incline of the treadmill by placing objects under the treadmill.
23.Inspect and properly tighten all parts of the treadmill regularly.
24.Never drop or insert any object into any opening on the treadmill.
25.DANGER: Always unplug the power cord immediately after use, before cleaning thetreadmill, and
before performing the maintenance and adjustment procedures described inthis manual.Never
remove the motor hood unless instructed to do so by an authorizedservice representative. Servicing
other than the procedures in this manual should be per-formed by an authorized service representa-
tive only.
26.This treadmill is intended for in-home use only. Do not use this treadmill in any com-mercial,ren-
tal, or institutional setting.
27.WARNING:
lf the supply cord is damaged, it must be replaced by the manufacturer, its service agent orsimilarly
qualified persons in order to avoid a hazard.This appliance is not intended for useby persons (includ-
ing children) with reduced physical, sensory or mental capabilities, orlack of experience and knowle-
EN
dage, unless they have bee n given supervision or instructionconcerning use of the appliance by a
person responsible for their safety. chi ldren should besupervised to ensure that they do not play
with the appliance.
28.Install the treadmill on a flat level surface with a suitable volt/Hz which marked in themachine
label, grounded outlet.
29.Allowed temperature: 5 to 40 degrees. If the treadmill has been exposed to cold tem-pera-
tures,allow it to warm to room temperature before turning on the power.If you do notdo this, you
may damage the console displays or other electrical components.
2