LGB Mogul Instructions De Service page 9

GB USA
THE PROTOTYPE
The Mogul locomotive is an Ame-
rican classic. During the late
1800s and early 1900s, more
than 10,000 of these versatile
locos were built for freight and
passenger service throughout
North America.
The term "Mogul" refers to the
"2-6-0" wheel configuration of
these locos: two small guide
wheels followed by six big driving
wheels and no trailing wheels.
THE MODEL
This detailed replica features:
- weather-resistant construction
- prototypical livery and lettering
- operating drive rods
- authentic steam piping and
detailing
- detailed cab
engineer and controls
- digital electronic steam sound
with
- synchronized steam "chuff"
sound
- prototypical American whistle
sounds
- magnetic bell and whistle trig-
ger
- air pump, steam drain, and
boiler leakage sounds when
stopped
- flickering firebox
- three-way power control switch
- protected gearbox with seven-
pole Bühler motor
- six powered wheels
- one traction tire
- ten power pickups (8 wheel,
2 shoe)
- voltage stabilization
(5 volt)
- smoke generator (5 volt)
- automatic directional lanterns
- reliable "flat"
socket
- "Bear Trap" smoke stack (25192
only)
- length: 665 mm (26.1 in)
- weight: 4600 g (10.1 lb)
THE PROGRAM
This model is part of the LGB pro-
gram of quality G-scale trains and
accessories. With this model, we
recommend:
- 34800 C&S Passenger Car, 68
- 34810 C&S Combine, 34
- 40680 D&RGW Stock Car,
Green
- 50100 JUMBO Power Pack,
10
interior with
circuit
multi-purpose
230V, 20V, 1A
- 50101 JUMBO Power Pack,
110V, 20V, 1A
For more information on the com-
plete LGB program, see the LGB
catalog.
OPERATION
Preparation
Attach the engine to the tender:
- Plug the wiring cable (Fig. 1b)
from the engine into the socket
on the tender.
- Slip the coupling hook on the
engine over the loop on the ten-
der.
Attention! The wiring cable can
be damaged by rough handling.
Remove the cable gently from the
socket. If the model operates
erratically or improperly, check
the cable.
Attention! This "digital" engine
should only be used with the
included tender. The tender is
electronically compatible with the
engine. Other tenders may dama-
ge the engine electronics.
Operating Modes
This model has a three-way
power control switch mounted
inside the cab (Fig. 1a, 2):
Position 0: All power off
Position 1: Power to lights and
smoke generator
Position 2: Power to lights, smoke
generator and motors
(factory pre-set)
Multi-Train System
25192 and 26192: This model
has a "D" gearbox and decoder
interfaces, one in the loco and
one in the tender. It can be equip-
ped with two LGB Multi-Train
System Decoders (55020) using
Decoder Interface
(55026).
When all decoders are installed,
the Train Mouse loco function but-
ton will control multiple functions,
depending on the number of
times the button is pushed. Push
the button in intervals of 0.6 to 1.0
second.
Press 1x: Whistle
Press 2x: Bell
Press 3x: Smoke generator on/off
Press 4x: Sound on/off
Press 5x: Firebox on/off
For more information, contact
your authorized LGB retailer or an
LGB service station (see Factory
Service). We recommend factory
installation of decoders (see Fac-
tory Service).
Hint: For Multi-Train System "digi-
tal" operation, set the three inter-
Cables