Britax EMBLEM ALLEGIANCE Guide D'utilisation page 31

Impact Absorbing Tether
Failure to follow the guidelines below may cause the child
seat not to perform as intended�
• The tether must be used at all times when installing
• Attach the tether only to tether anchors identified by
• If your vehicle does not currently have a tether anchor
• Store the tether in the pouch on the back of the child
Tether anchor locations vary from
vehicle to vehicle� Check your
vehicle owner's manual and look for
the tether anchor symbol shown in
the diagram to help identify where
the top tether anchor points are
located in your vehicle�
Using the Tether
IMPORTANT:
facing installations�
To attach the tether to a tether anchor:
1� Firmly press the hook over
2� Pull the loose end of the
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 29 14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 29
EMBLEM/ALLEGIANCE Canadian User Guide
this child seat forward-facing� Using the tether will
improve the stability of your child seat and reduce the
risk of injury�
your vehicle manufacturer as tether anchorage points�
Only use the designated tether anchor for each seating
position�
attachment, refer to your vehicle owner's manual or
contact your vehicle man u fac tur er for assistance� DO
NOT modify your vehicle without advice from your
vehicle manufacturer�
seat when not in use� DO NOT install the child seat
with the tether attached to the carry clip�
Do not use the top tether strap with rear-
the tether anchor point�
webbing to remove slack
from the tether�
NOTE: If the tether is
too short for use in your
vehicle, contact Britax
Consumer Services to
obtain a tether extender.
29
11/16/23 10:47 AM 11/16/23 10:47 AM