Publicité
Les langues disponibles
Les langues disponibles
BRITAX Child Safety, Inc.
Lap Belt Installation
1� Remove the tether from the
2� Adjust this child seat to
3� Loosen the harness�
4� Pull the head restraint/
5� Route the vehicle seat
6� Push down on the middle
18
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 18
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 18
pouch and place it up and
over the child seat back�
position 1 or 2 and place
forward-facing on the
vehicle seat (see page 24)�
NOTE: Ensure that no
more than 7.5 cm (3 in.) of
the base hangs over the
edge of the vehicle seat.
IMPORTANT:
Your child
seat may not perform as
intended if the base of the
child seat is not flat on the
vehicle seat�
a� Lift harness adjuster
lever and pull both
harness straps
forward�
b� Remove the infant
positioning pillow and
unbuckle the harness�
head pad cover up,
then pull the seat cover
forward to access the
forward-facing belt path�
belt through the forward-
facing belt slots, ensuring
the vehicle belt is not
twisted, then buckle�
IMPORTANT:
Do not
use lock-offs for lap belt
installations�
of the child seat while
pulling the vehicle belt to
remove all slack�
NOTE: Ensure that the
vehicle belt is locked as
directed by your vehicle
owner's manual.
7�5 cm
7�
8�
11/16/23 10:47 AM
11/16/23 10:47 AM
Publicité
