Publicité
Les langues disponibles
Les langues disponibles
BRITAX Child Safety, Inc.
Lap-Shoulder Belt Installation
1� Remove the tether from
2� Adjust this child seat to
3� Loosen the harness�
4� Pull the head restraint/
5� If applicable, open the
6� Route the vehicle belt
7� Push down into the rear
16
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 16
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 16
the pouch and place it up
and over the child seat
back�
position 1 or 2 and place
forward-facing on the
vehicle seat (see page 24)�
NOTE: Ensure that no
more than 7.5 cm (3 in.) of
the base hangs over the
edge of the vehicle seat.
IMPORTANT:
Your child
seat may not perform as
intended if the base of the
child seat is not flat on the
vehicle seat�
a� Lift harness adjuster
lever and pull both
harness straps
forward�
b� Remove the infant
positioning pillow and
unbuckle the harness�
head pad cover up,
then pull the seat cover
forward to access the
forward-facing belt path�
green lock-off closest to
where the vehicle belt will
be buckled (see page 24)�
a� Open the locking tab�
b� Open the clamp�
through the forward-facing
belt slots, ensuring the
vehicle belt is not twisted,
then buckle�
of the child seating area
with moderate force while
removing all slack from
the bottom (lap) part of the
vehicle belt and close the
lock-off, if used�
IMPORTANT:
Both the
vehicle lap and shoulder
belts must be routed
through the lock-off�
7�5 cm
Locking
Tab
Clamp
5a
5b
11/16/23 10:47 AM
11/16/23 10:47 AM
Publicité
