Britax EMBLEM ALLEGIANCE Guide D'utilisation page 13

8� Push down into the
9� Push down into the middle
10� Replace the seat cover
Rear-Facing Installation with Lap-Shoulder Belt
9 All connections are secure and straps are not twisted�
9 No more than 7�5 cm (3 in�) of the base hangs over the
9 The anti-rebound bar is properly installed (see page 26)�
9 The child seat cannot be moved front to back or side to
9 The child seat is correctly installed when angle guide line
9 Tether webbing is stored in storage pouch� See page 30�
14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 11 14878600_A-1_USER GUIDE, EMBLEM ALLEGIANCE, CAN_BOOK.indb 11
EMBLEM/ALLEGIANCE Canadian User Guide
middle of the child
seating area with
moderate force while
removing all slack from
the bottom (lap) part of
the vehicle belt and close
the lock-off (see page 24)�
IMPORTANT: Both the
vehicle lap and shoulder
belts must be routed
through the lock-off�
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off�
and infant positioning
pillow, if required (see
page 24)�
edge of the vehicle seat�
side more than 2�5 cm (1 in�) at the belt path� If the child
seat is not secure, repeat installation or use a different
seating location�
is parallel to the ground when the car is parked on a level
surface� After the child is secured, the recline angle of the
child seat should be 30° – 45° from vertical (not to exceed
45°) when the car is parked on a level surface� See "Seat
Positions" on pages 24 - 25�
11
11/16/23 10:47 AM 11/16/23 10:47 AM