Publicité
48
11.4 NIGHT LIGHT™ REPLACEMENT
Your
The light has been pre-wired and is controlled from the remote
control.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
Unplug the wire harness / transformer from the FCM (Fan Control
Module) inside the appliance.
Remove the four screws that secure the lens frame.
This frame retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a clean
dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as
lamp and lens are special "high temperature" products. When re-installing, ensure
integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes in the lamp housing are necessary
for ventilation and must not be covered.
11.5 GLASS / DOOR REPLACEMENT
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
Place the door frame face down careful not to scratch the
A.
paint.
Center the gasketed glass inside the door frame with the thick
B.
side of the gasket facing up.
Bend the glass retainers located along the edge of the door
C.
frame over the gasket holding the glass in place. Careful not
to break the glass.
W415-0748 / C / 08.20.12
comes equipped with our "Night Light™".
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
LENSE
FRAME
WARNING
!
SCREWS
FIREBOX TOP
GASKET
GLASS
GLASS
RETAINER
DOOR
FRAME
56.1A
GASKET
LENSE
FRAME
Publicité
