Publicité
7.0 WIRING DIAGRAM / ELECTRICAL INFORMATION
7.1
ELECTRICAL CONNECTION
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT RIGGING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1
CANADIAN ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OF IF THE GAS SUPPLY HAS RAN OUT,
7.1.1 HARD WIRING CONNECTION
It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence
of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996
National electrical code in the United States.
7.1.2 SCHEMATIC
REMOTE
Receiver Wall Mount
RECEIVER
NFPA NO. 70 IN THE UNITED STATES.
WITH THE GLASS DOOR OPENED OR REMOVED.
BLOWER
ON
OFF
REMOTE
ON
Receiver Hearth Mount
Receiver
12 Pin
Connector
WARNING
!
ELECTRICAL CIRCUIT.
110V OUT
Fan Control Module (FCM)
OFF
Modulating 820
FAN AUX OUT
FCM-COM
TH
TP
Red
Black
OUT
TPTH
MOTOR
37
Night Lights
White
Green
W415-0748 / C / 08.20.12
Publicité
