Publicité
34
6.2
LOG SHIPPING BRACKET
Before installing the logs, you must fi rst remove the log shipping brackets. Lift up
to remove.
6.3
DECORATIVE BRICK PANEL INSTALLATION
Decorative panels may discolor after time.
Carefully remove the glass door and all logs see
A.
"FINISHING" section.
Remove the two screws holding the front portion of the rear
B.
air defl ector. Remove the pilot shield by removing the two
screws as illustrated.
Remove the 3 screws holding the burner down and carefully
C.
remove the burner.
Install the right brick panel by sliding the bottom edge of the
D.
panel down the right fi rebox side then pivot the top edge of
the panel into place against the fi rebox wall. Hold in place
with the brick retainers.
Rest the bottom edge of the rear panel on top of the rear
E.
portion of the air defl ector at the back of the fi rebox and
push into place. The rear panel is held in place when both
side panels are in position.
Install the left brick panel using the same method described
F.
in step 4.
Replace the burner, air defl ector, logs and glass door.
G.
NOTE: Due to the brittle material of the
bricks, care must be taken not
to bend or force them into place.
Refractory panels require a 24 hour
curing period on a low fl ame.
W415-0748 / C / 08.20.12
LOG SHIPPING
BRACKET
STEP
B
STEP
C
E
D
HERRINGBONE PATTERN ILLUSTRATED
PILOT SHIELD
F
Publicité
