Publicité
Les langues disponibles
Les langues disponibles
Installation
• When using the supplied flexible connecting hose, the minimum bending radius of 27 mm must be observed
at all times. The connecting hose must not be subjected to any tensile or compressive effects during assembly
and when in use.
• The minimum requirements for the required water resistance must be complied with. The required water
resistance of the can be obtained from your water supply company.
• The water pipes must not exert any mechanical force on the water connections of the instantaneous water
heater during installation and operation. If this cannot be guaranteed due to the installation conditions, we
recommend the use of flexible connections.
• This appliance is not suitable for warm water supply to showers.
2.3 Water connection
1. Position the instantaneous water heater with the water connectors vertically upwards for direct connection to
the tap.
2. Secure the wall bracket to the wall with suitable screws and dowels.
3. Place the appliance onto the wall bracket and snap it into position. Only use the appliance if it is fitted cor-
rectly to the wall bracket.
Fig. 5: "Installing the wall bracket"
4. Rinse the water pipes thoroughly before connecting them to the appliance.
5. Connect the water connectors with the relevant tap connectors. The water inlet is indicated in blue on the
rating plate (under the cover) and the water outlet in red.
23
CLAGE
EN
Publicité
