Powerfix Profi HG01477A-1 Instructions D'utilisation Et Consignes De Sécurité page 13

of lashing devices according to EN 12195-1. Only lashing systems labelled for lashing down
with STF (standard tension force) may be used for friction lashing.
HG01477A-1:
Use the S hook to securely attach the lashing strap to the load.
j
j Open the ratchet handle
webbing can be inserted into it (see Fig. A III).
4
Insert the webbing
j
the slotted shaft
Tighten the lashing strap by moving the handle of the ratchet backwards and forwards
j
(see Fig. A I - III). Tighten the lashing strap until you have obtained the tension you wish
to have.
Note: Make sure that webbing
times around the slotted shaft
j Bring the ratchet handle
secure.
HG01477A-2:
Loop the lashing strap around the load.
j
j Press the clamping lock
from below (see Fig. C).
Carefully pull the webbing
j
want. Then release the clamping lock
Releasing the lashing strap
Q
CAUTION! Check before releasing the strap that the load is stable. Make sure that
the load is stable even without the lashing strap and that it cannot fall down.
CAUTION! RISK OF INJURY! Make sure that nobody is near the load when you
release the lashing strap. Falling parts could cause injuries.
CAUTION! RISK OF INJURY! When opening the lashing equipment, the preload
force is released at a stroke. That is why you should open the lashing strap with the utmost
caution.
Note: Before starting to unload, make sure that the lashing equipment is released so that
the load can be lifted freely.
HG01477A-1:
Open the ratchet handle
j
Press the ratchet lock
j
(see Fig. B).
Pull the webbing
j
j Release the S hook and thus the lashing strap from the load.
and place the slotted shaft
1
into the slotted shaft
4
until the webbing
3
is wound at least 1.5 times to a maximum of 3
4
.
3
into the basic position (see Fig. A I). The load is now
1
down and pass the webbing
5
through the clamping lock until you get the tension you
6
into the maximum position (see Fig. A III).
1
and open the ratchet handle
2
completely out of the slotted shaft
4
3
of the ratchet. Carefully pull it through
3
lies snug against the load.
4
6
.
5
until the end stop
1
.
3
into the position so that the
through the clamping lock
GB/IE/NI 11