Publicité
Les langues disponibles
Les langues disponibles
Accumulated split wood and wood chips can create a hazardous work environment. Never continue to
work in a cluttered work area which may cause you to slip, trip or fall. Keep your work area clean and tidy.
WARNING! Do not become careless in assuming your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the
tool, neglecting strict compliance to the safety instructions given with the tool.
Improper us of the tool or failure to comply with the provided safety instructions in
this manual can cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Stay alert for your surroundings and especially for any danger that you may not
hear while using the tool.
VI. MAINTENANCE
B
EFORE ANY INTERVENTION ON PRODUCT
Wear protective gloves to avoid any injury hazard.
Carefully observe the following points so as not to interfere with the proper operation of log
splitter: - Clean the machine thoroughly after each use.
- Eliminate resin residues.
- Regularly lubricate the piston rod by means of oil spray.
- Check the oil level, and refill as deemed necessary.
Reminder: Make sure to maintain the machine in good working condition, carry out regular maintenance of the
machine after each use and before storage .Any breach or default of adequate maintenance reduces the life of the
machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform maintenance and proper
cleaning, DO NOT use non-compliant replacement parts and do NOT dismantle yourself the machine or change the
security features.
6.1- Freeing a jammed log
It may occur that the log remains jammed during splitting.
1. Switch off the machine and remove the plug from the socket.
2. Do not remove the jammed log with your hands!
3. Try to move the jammed log carefully using a crowbar to loosen it.
- Do not damage the ram and splitting wedge.
- Never attempt to free the jammed log using a hammer.
- Never attempt to release the jammed log using a saw.
- Do not ask for help to a second person. Only one person should be around the machine.
6.2- Checking and replacing the hydraulic oil
a) Checking the oil level
1. The machine must be on levelled surface with cylinder in
its collapsed position.
2. Remove the dipstick gauge (3).
3. Clean the dipstick and the gasket.
4. Insert the dipstick into the opening.
5. Remove the dipstick.
- When the oil level is between the two marks [a] and [b],
the tank contains enough oil.
,
DISCONNECT THE PRODUCT FROM ITS POWER SOURCE
.
Page 38 / 62
Publicité
