Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
4.1- Unpacking
We recommend that at least 2 persons unpack the log splitter package
Remove product from its packaging.
Check that product and accessories are not damaged.
4.2- Assembly
For packing reasons, the machine is not completely assembled and therefore requires some assembly
from the user.
Wheels assembly
Insert wheel axle (B) through the holes on the oil tank.
Then, mount a wheel (2) on each side of the axle and
secure with a cotter pin (A).
Slightly bend the cotter pin to prevent it from falling
out.
Control handles assembly
- Put LEFT handle arm in its position: insert arm's tube
(A) into the rocker bracket (B).
- Insert long bolt (C) and fix it on its lower side with the
washer and nut.
- Mount the hoop guard (D) into position with 2
crosshead screws (E).
- Repeat above assembly to the RIGHT arm.
- Make sure to tighten all nuts and screws after control
arm assembly.
Side retaining arm assembly
- Put LEFT bottom arm in its position: insert arm's tube
(A) into the holding bracket (B).
- Insert 2 bolts (C) and fix it on the other side with 2
washers and 2 nuts.
- Repeat above assembly steps to mount LEFT upper
arm, RIGHT lower arm and RIGHT upper arm.
- Make sure to tighten all nuts and bolts after retaining
arm assembly.
Page 31 / 62
Publicité
