Publicité
Les langues disponibles
Les langues disponibles
Assembly / Commissioning
leasing and rolling out!
Therefore, it is recommended to carry out
the work with an additional person.
Push the flux-cored wire through the wire
„
31
feed guide
(see Fig.. M)
Guide the wire along the feed roll
„
and push it into the hose package holder
32
(see Fig. N).
Swivel the thrust roller unit
„
the feed roll
19
(see Fig. O).
Mount the adjustment screw
„
O).
Set the counter pressure with the adjust-
„
ment screw. The welding wire must be
firmly positioned between the thrust roller
and feed roll
19
thout being crushed (see Fig. O).
Switch on the welding device on the
„
main
5
switch.
Press the torch button
„
Now the wire feed system pushes the
„
welding wire through the cable assembly
12
and the torch
As soon as 1 – 2 cm of the wire protru-
„
des from the torch neck
11
torch button
again (see Fig. P).
Switch off the welding device on the
„
main switch.
Screw the welding nozzle
„
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. Q). When using the
delivered welding wire (Ø 0.9 mm), the
welding nozzle
15
mm must be used.
Push the torch nozzle
„
torch neck with a turn to the right
Fig. R).
Always unplug the mains
plug from the power socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
40
GB / IE
19
28
towards
27
(see Fig.
in the upper guide wi-
11
.
10
.
33
, release the
15
back on.
15
with the labeling 0.9
back on to the
9
(see
33
z Commissioning
z Switching the device on and
off
Switch on the welding device on and off
„
the main switch
to use the welding device for an exten-
ded period, remove the plug from the
power socket. This is the only way to
completely de-energize the device.
z Setting the welding current
The rotary switch for the welding current set-
ting
on the front of the welding device can
7
be used to set the desired welding currents.
The corresponding settings can be found in
the following table.
Voltage (V)
Wire feed
A
2 – 4
B
3 – 5
C
3 – 6
D
4 – 8
E
5 – 9
F
5 – 10
G
5 – 10
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
z Setting the wire feed
In order to generate a constant arc, the set-
ting wheel for the wire feed
to fine-tune the wire feed. It is recommended
to use a setting in the middle range to start
with, and then reduce or increase the speed
5
. If you do not intend
Welding
current (A)
25 – 75
55 – 85
60 – 100
65 – 105
75 – 110
80 – 115
85 – 120
8
can be used
Publicité
