Publicité
Les langues disponibles
Les langues disponibles
Check that the delivery is complete.
„
The welding nozzles can be stowed
„
away in the storage compartment for
welding nozzles
z Assembly
z Assembling the welding
mask
Place the dark welding glass
„
mask with the writing on the top
Fig. C). The writing on the dark welding
21
glass
must now be visible from the
front of the welding mask.
22
Push the handle
„
the corresponding notch of the mask, un-
til it snaps into place (see Fig. D).
z Inserting the flux-cored
wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
Note: Different welding wires will be nee-
ded depending on the application. Welding
wires with a diameter of 0.6 – 1.0 mm can
be used with this device.
Feed roll, welding nozzle and wire cross
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
Unlock and open the cover of the wire
„
1
feed unit
by raising the threaded rod
along the elongated hole.
Unlock the roller unit by turning the roller
„
29
mount
anti-clockwise (see Fig. F).
Pull the roller mount
„
Fig. F).
Note: Make sure that the end of the wire
does not come loose and cause the roll to
.
26
21
into the
20
(see
from the inside into
29
off the shaft (see
roll out on its own. The end of the wire may
not be released until during assembly.
Completely unpack the flux-cored wire
„
17
welding reel
, so that it can unrolled
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft.
„
Make sure that the roll unwinds on the
side of the
31
wire feed guide (see Fig.
G).
Place the roll mount
„
it by pressing and turning it clockwise
(see Fig. G).
Undo the adjustment screw
„
it upwards (see Fig. H).
Turn the thrust roller unit
„
(see Fig. I).
Loosen the feed roll holder
„
it anti-clockwise and pull it upwards and
off
(see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thickness
is indicated. If necessary, the feed roll
has to be turned over or replaced. The
supplied welding wire (Ø 0.9 mm) must
be used in the feed roll
cified wire thickness of Ø 0.9 mm. The
wire must be positioned in the upper
groove!
Put on the feed roll holder
„
screw clockwise direction.
Remove the torch nozzle
„
and turning it clockwise (see Fig. K).
Unscrew the welding nozzle
„
K).
Guide the hose package
„
the welding device as straight as possi-
ble (place it on the floor).
Take the wire end out of the edge of the
„
spool (see Fig L).
Trim the wire end with wire scissors or a
„
diagonal cutter in order to remove the da-
maged, bent ends of the wire (see Fig. L).
Note: The wire must be kept under ten-
sion the entire time in order to avoid re-
Before use / Assembly
29
back on and lock
27
and swing
28
to the side
30
by turning
19
, check
19
with the spe-
30
again and
9
by pulling it
15
(see Fig.
12
away from
GB / IE
39
Publicité
