Publicité
Les langues disponibles
Les langues disponibles
♦
Switch the appliance on by pressing the ON/
OFF switch
.
♦
Set a speed suitable for the work using the
speed control
.
♦
Switch the appliance off by pressing the ON/
OFF switch
again.
Grinding
♦
Place the workpiece on the tool rest
the workpiece slowly towards the grinding disc
at the required angle until the workpiece
and the grinding disc
each other.
♦
Move the workpiece evenly backwards and
forwards in order to achieve optimal results. This
also ensures that the grinding disc
down more evenly.
Changing the grinding disc/buffing disc
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
►
The grinding
or buffing disc
not be any larger than the prescribed diameter.
►
Replace the grinding
when the outer diameter is less than 50 mm.
NOTE
►
Please note that you will require tools which
are not included in delivery for the assembly.
♦
Using a Phillips screwdriver, unscrew the fixing
bolts
from the side protective covers
E). Remove the protective covers
♦
If you want to change the buffing disc
remove the locking pin
on the flexible shaft
ment of the flexible shaft
♦
Unscrew the union nut
using a 17 mm wrench. Hold the affected grind-
ing
or buffing disc
create a suitable counterpressure.
│
GB │ IE
■
32
. Guide
come into contact with
is worn
used may
or buffing disc
(see fig.
on both sides.
,
from the attachment
38a
. Then pull the attach-
off the shaft
.
from the shaft
firmly in one hand to
♦
Remove the tension disc
or buffing disc
.
♦
Place the new grinding
the shaft
.
♦
Push the tension disc
♦
Screw the union nut
♦
Re-tighten the union nut
or buffing disc
that you have just attached
firmly in one hand to create a suitable counter-
pressure.
WARNING! RISK OF INJURY!
►
Never use the grinding
without the protective cover
CAUTION! PROPERTY DAMAGE!
►
Do not tighten the union nut
since the grinding disc
break.
♦
Refit the protective cover
by tightening the fixing screws
Fitting the flexible shaft
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
♦
Screw the flexible shaft
thread
of the appliance. To do this, push the
axle core of the flexible shaft into the square
hole on the connecting thread
ing nut
anticlockwise to tighten it.
WARNING – RISK OF INJURY!
►
Make sure that the eye shields
down to the tool rests
unintentional contact with the grinding
buffing disc
.
►
After use, remove the flexible shaft
the appliance. Otherwise, the flexible shaft
could start thrashing about in an uncon-
trolled manner and cause an injury when you
switch the appliance on.
and grinding
or buffing disc
on
back onto the shaft
back onto the shaft
. Hold the grinding
or buffing disc
.
too tightly
could otherwise
and fix it in place
.
onto the connecting
. Turn the lock-
are folded
. This can prevent
or
from
PDFW 120 A1
.
.
Publicité
