Publicité
Les langues disponibles
Les langues disponibles
Operation
Fitting/changing the saw blade
Always remove the battery pack before changing
the saw blade
!
1. Set the cutting depth (using the locking screw
) to the minimum position, 0 mm.
2. Swing the blade guard
lease lever
and put the appliance down.
3. Press the spindle lock button
gages) and use the hex key
clamping screw
. Now remove the clamping
screw
and the clamping flange
fig. A).
Fig. A: Changing the saw blade
4. Remove the saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the hex key
screw/washer
.
WARNING!
►
The arrow on the saw blade
respond to the arrow showing the direction of
rotation
(running direction shown on the
blade guard
).
■
Ensure that the saw blade
rotational speed of the tool.
│ GB │ IE
■
26
back using the re-
(until it en-
to release the
(see also
.
is carried out in the
(until it engages)
to tighten the clamping
must cor-
is suitable for the
Rip fence
♦
Undo the wing screw
into the rip fence slot
♦
Set the desired cut width with the help of the
scale on the rip fence
base plate
(see also fig. B).
The right recess in the base plate is for a cutting
angle of 0°. The left-hand recess in the base
plate is for a cutting angle of 45°.
Fig. B: Cutting width 3 cm
♦
Retighten the wing screw
Connecting the sawdust extraction
device
♦
Attach the adapter for dust extraction
chip ejector
.
Optional, depending on the diameter of the
dust and sawdust extraction.
♦
Connect an approved dust and chip extraction
device.
NOTE
►
When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
and insert the rip fence
.
and the cut out in the
.
to the
PHKSA 20-Li A2
Publicité
