Parkside PWS 125 I8 Instructions D'utilisation Et Consignes De Sécurité page 22

Always check the product before using it for
obvious deficiencies such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Examine the grinding
disc in particular. Exchange the damaged
parts.
˜ Cleaning
m WARNING!
Do not use any cleaning agent or solvent.
u
Chemical substances can etch the plastic
parts of the product.
Never clean the product under running
u
water.
Thoroughly clean the product after every
o
use.
Clean the ventilation openings and the
o
surface of the product with a soft brush or
cloth.
˜ Servicing (fig. C)
Replacing carbon brushes
m WARNING!
Switch off the product and
disconnect it from the mains before
replacing attachments, cleaning and
when not in use.
1. Loosen the screw
6 ] [
cover (fig. A).
[ 5 ]
2. Remove the maintenance cover.
3. Lift the compression spring
groove for the compression spring
carbon brush .
[ ]
4. Remove the contact plug
contact shoe .
[ ]
5. Pull out the carbon brush from the guide.
6. Insert a new carbon brush into the guide.
of the maintenance
out of the
[ ]
of the
[ ]
from the
[ ]
7. Place the connector
groove for the compression spring. Lead the
connector through the side opening of the
guide.
8. Slide the contact plug on the contact shoe.
9. Replace the compression spring on the
groove for the compression spring of the
carbon brush.
10. Reattach the maintenance cover using the
screw.
11. Repeat steps 1 to 10 on the other side
of the product. The carbon brushes must
always be replaced in pairs.
˜ Storage
Store the product in a dry place well out of
o
reach of children.
Grinding discs must be dry and stored
o
upright and should never be stacked.
˜ Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the
packaging materials for waste
separation, which are marked with
abbreviations (a) and numbers
(b) with following meaning: 1–7:
plastics/20–22: paper and
fibreboard/80–98: composite
materials.
Product:
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
in an arc past the
[ ]
GB/IE/NI 21