Parkside PWS 125 I8 Instructions D'utilisation Et Consignes De Sécurité page 13

7) The dimensions of the accessory
mounting must fit the dimensions
of the mounting hardware of
the power tool. Accessories that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
8) Do not use a damaged accessory.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear.
If power tool or accessory is
dropped, inspect for damage or
install an undamaged accessory.
After inspecting and installing an
accessory, position yourself and
bystanders away from the plane of
the rotating accessory and run the
power tool at maximum no-load
speed for 1 minute. Damaged
accessories will normally break apart
during this test time.
9) Wear personal protective
equipment. Depending on
application, use face shield, safety
goggles or safety glasses. As
appropriate, wear dust mask,
hearing protectors, gloves
and workshop apron capable
of stopping small abrasive or
workpiece fragments. The eye
protection must be capable of stopping
flying debris generated by various
operations. The dust mask or respirator must
be capable of filtrating particles generated
by your operation. Prolonged exposure to
high intensity noise may cause hearing loss.
10) Keep bystanders a safe distance
away from work area. Anyone
entering the work area must
wear personal protective
equipment. Fragments of workpiece or
of a broken accessory may fly away and
cause injury beyond immediate area of
operation.
12 GB/IE/NI
11) Hold the power tool by insulated
gripping surfaces only, when
performing an operation where
the cutting tool may contact hidden
wiring or its own cord. Contact with
a "live" wire will also make exposed metal
parts of the power tool "live" and could
give the operator an electric shock.
12) Position the cord clear of the
spinning accessory. If you lose control,
the cord may be cut or snagged and
your hand or arm may be pulled into the
spinning accessory.
13) Never lay the power tool down
until the accessory has come to a
complete stop. The spinning accessory
may grab the surface and pull the power
tool out of your control.
14) Do not run the power tool while
carrying it at your side. Accidental
contact with the spinning accessory could
snag your clothing, pulling the accessory
into your body.
15) Regularly clean the power tool's
air vents. The motor's fan will draw
the dust inside the housing and excessive
accumulation of powdered metal may
cause electrical hazards.
16) Do not operate the power tool
near flammable materials. Sparks
could ignite these materials.
17) Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocution
or shock.
Further safety instructions for all
operations – Kickback and related
warnings
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush
or any other accessory. Pinching or snagging
causes rapid stalling of the rotating accessory
which in turn causes the uncontrolled power
tool to be forced in the direction opposite of the
accessory's rotation at the point of the binding.
For example, if an abrasive wheel is snagged