Parkside PWS 125 I8 Instructions D'utilisation Et Consignes De Sécurité page 12

6) Keep cutting tools sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less likely to
bind and are easier to control.
7) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations different
from those intended could result in a
hazardous situation.
8) Keep handles and grasping
surfaces dry, clean and free from
oil and grease. Slippery handles
and grasping surfaces do not allow for
safe handling and control of the tool in
unexpected situations.
Service
1) Have your power tool serviced
by a qualified repair person
using only identical replacement
parts. This will ensure that the safety of
the power tool is maintained.
˜ Grinder safety warnings
m WARNING!
Dust from materials such as lead paint,
u
some types of wood, and metal can be
harmful to your health.
Contact with or inhaling this type of
u
dust can present a danger to the user or
persons nearby.
m WARNING!
Wear safety glasses and a dust
mask!
˜ Angle grinder warnings
Safety warnings common for grinding
and abrasive cutting-off
1) This power tool is intended for
use as a grinder and abrasive
cutting machine. Follow all safety
instructions, instructions for use,
illustrations and data included with
the device. Failure to heed the following
instructions can result in electric shock, fire
and/or serious injury.
2) Operations such as sanding, wire
brushing, polishing and hole
cutting are not to be performed
with this power tool. Operations for
which the power tool was not designed
may create a hazard and cause personal
injury.
3) Do not convert this power tool
to operate in a way which is not
specifically designed and specified
by the tool manufacturer. Such a
conversion may result in a loss of control
and cause serious personal injury.
4) Do not use accessories which
are not specifically designed
and specified by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
5) The rated speed of the accessory
must be at least equal to the
maximum speed marked on the
power tool. Accessories running faster
than their rated speed can break and fly
apart.
6) The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately guarded
or controlled.
GB/IE/NI 11