Parkside PLS 48 D2 Mode D'emploi page 28

Connect the plug into a suitable mains socket and press the ON / OFF
r
switch into the position "I" . Turn the temperature regulator
desired temperature .
NOTE
Before use, remove the protective cap from the soldering tip
f
Before using the soldering station for the first time and also when
f
using each new soldering tip, the soldering tip must be
first .
The prerequisite for perfect soldering is the use of suitable
f
solder . In addition, perfect soldering can only be achieved when
the correct soldering temperature is achieved . If the soldering
temperature is too low, the solder does not flow sufficiently and
causes dirty soldering joints (so-called cold soldering joints) . Due
to soldering temperatures which are too high, the solder burns
and the solder does not flow . In addition, the materials to be
processed can be destroyed .
The following temperature settings are for the most common applications .
Differences are possible depending on the solder / manufacturer . The
different levels have no locking function, which ensures the same consistent
setting at the pre-selected level . Slight deviations are possible .
Minimum setting = Room temperature
Level 1: Approx . 100 °C - Warming up level and for solders with
corresponding low melting temperature .
Level 2: Approx . 200 °C Melting point of the most commonly
PLS 48 D2
q
and set the
t
t
tinned
GB | IE |
.
25