Publicité
Les langues disponibles
Les langues disponibles
Taking a break during the training session
If you wish to take a break during a program, briefly press the Pause key. An acoustic signal sounds
and the pause symbol "II" symbol appears on the display. By pressing the key again you can contin-
ue the program.
Reading off the number of training sessions
You can read off the number of your training sessions on the display. The numbers after the program
denote how often you have already fully completed a program. These numbers are stored until there
is a battery change.
6. Cleaning
― Remove the batteries from the device each time you clean it.
― Clean the device with a slightly moistened cloth. In case of more extreme soiling you can also
moisten the cloth with mild soapy water.
― Never drop the device.
― Ensure that no water penetrates into the device. If this should ever happen then only use the de-
vice once it is completely dry.
― Do not use any chemical cleaners or abrasive agents for cleaning.
― Once you have removed the device (operating unit), you can wash the belt in luke warm water.
Use mild soapy water or a liquid detergent for this purpose. Do not use bleaches.
― The belt is unsuitable for machine washing.
7. Technical Specifications:
Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement from
Maximum permissible operating conditions:
Maximum permissible storage conditions:
Explanation of symbols:
Changes to the technical specifications introduced for reasons of updating without notice are reserved.
EM 30
3 x 1.5 V AAA (type LR 03)
approx. 10 x 10 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 330 g
70 to approx. 130 cm. (28 – 52 Inch)
0 °C to +40 °C, 20-65% relative humidity
0 °C to +55 °C, 10-90% relative humidity
- Application part type BF
- Read the Instructions for Use.
16
Publicité
