Parkside PAAP12A1 Traduction Des Instructions D'origine page 31

Use
NOTE
► Always switch the hand grinder on before
applying it to the workpiece.
Switching the appliance on:
♦ Press the safety lock-out
symbol to unlock the ON/OFF switch
♦ Press the ON/OFF switch
Switching the appliance off:
♦ Release the ON/OFF switch
♦ Press the safety lock-out
the symbol to lock the ON/OFF switch
2-speed gearbox
CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (speed selector switch
position: 1)
you can reach a speed of approx. 2800 rpm.
In second gear (speed selector switch
position: 2)
you can reach a speed of approx. 8300 rpm.
Grinding
WARNING!
► Dust from materials such as paints, some types
of wood and metal can be harmful to health.
► Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and any other
people in the vicinity.
► Wear safety goggles and a protective dust
mask!
NOTE
► Make sure that a suitable sandpaper is
correctly fitted on the polishing disc
│ GB │ IE
■ 26
on the side with the
.
.
.
on the side with
.
only
in
in
.
♦ Switch the appliance on.
♦ Guide the appliance across the workpiece
parallel to its surface.
♦ Move the unit parallel and evenly over the
surface to be sanded.
♦ Do not press the appliance down. Pressing
down hard does not improve the performance.
♦ When you are satisfied with the result, turn off
the appliance.
Polishing
♦ Add a little polish to the fitted polishing attach-
ment and the workpiece.
,
–
Polishing hood
–
Polishing hood
–
Fake fur attachment
♦ Manually spread the polish over the surface
you want to polish.
NOTE
► Do not apply the polish to the same surface
too often as the particles it contains could
damage the finish.
► Mask any plastic components beforehand as
these could be faded by the polish.
♦ Switch the appliance on.
♦ Guide the appliance across the workpiece
parallel to its surface.
♦ Move the appliance parallel and evenly over
the surface being polished.
♦ Do not press the appliance down. Pressing
down hard does not improve the performance.
♦ When you are satisfied with the result, turn off
the appliance.
ATTENTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken. Use suitable clamps to prevent the
workpiece from slipping.
(orange) for pre-polishing
(black) for final polishing
for high-gloss polishing
PAAP 12 A1