Before use
Removing/charging/inserting the
battery pack
NOTE
►
The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hour. This guarantees
full battery performance. You can charge the
lithium-ion battery at any time without
shortening its service life. Interrupting the
charging process does not damage the
battery.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between
0°C and 50°C.
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
it to the charger.
♦
To remove the battery pack
release button
and pull the battery pack
out of the appliance.
♦
Insert the battery pack
charger
.
♦
Insert the power plug into the socket. The
charge control LED
♦
The green charge control LED
charging is complete and the battery pack
is ready for use.
♦
Unplug the high-speed charger from the wall
socket.
♦
Push the battery pack
PAAP 12 A1
from or connect
, press the
into the high-speed
lights up red.
indicates that
into the appliance.
Checking the battery charge level
When the appliance is switched on, the remaining
charge is shown on the battery LED
RED/ORANGE/GREEN = maximum charge
RED / ORANGE = medium charge
RED = low charge – charge the battery
Assembly/disassembly of the
polishing disc
♦
Press the spindle lock
♦
Screw the polishing disc
screw thread
.
♦
Proceed in the reverse order to remove the
polishing disc
.
Fitting the attachments
ATTENTION!
►
Be sure to remove the battery pack before
fitting or removing the attachments
,
.
♦
The polishing disc
,
,
,
are fitted with corresponding
Velcro fasteners.
♦
To change them, lift the side of the attachment
,
,
,
and pull it off the polishing
disc
.
♦
First choose a sandpaper
press it onto the polishing disc
it is properly centred.
♦
Now select the polishing hood
pre-polishing and push it onto the polishing
disc
. Make sure it is properly centred.
♦
Now select the polishing hood
final polishing and press it onto the polishing
disc
. Make sure it is properly centred.
♦
For the final finish, select the fake fur attachment
and press it onto the polishing disc
Make sure it is properly centred.
Fitting the additional handle
♦
The additional handle
the left or right side of the appliance head,
depending on the mode of operation.
as follows:
and hold it down.
clockwise onto the
,
,
and supplied attachments
for sanding and
. Make sure
(orange) for
(black) for
.
can be screwed onto
GB │ IE
│
25
■