ProMinent DULCOTEST DO 1-mA-20 ppm Mode D'emploi page 35

ProMinent ®
The railing bracket can be attached directly onto a concrete wall to
act as a mounting for the standard PVC pipe (railing bracket order
number 1020536).
Max. 8 mm
or 5/16
Fig. 4: Attaching to concrete wall
6.1.3 Placing the sensor insert, DO 1 sensor
IMPORTANT
• Do not remove the silicon paste on the back of the sensor
insert.
• It protects the contacts from short circuit even if some water
has penetrated.
• The bracket for the sensor insert must be tightened and
slackened only by hand. (The sensor unit holder has a bayonet
fitting).
Disconnect the sensor from the power supply.
Place the sensor insert into the transmitter as shown in fig. 5
(insert the two lugs on the bottom of the sensor into the corre-
sponding holes on the transmitter).
Rotate the bracket for the sensor insert onto the transmitter until
the bayonet fitting engages.
Order number, sensor unit for DO 1-mA-20 ppm: 1020534
Mounting
35