LIVARNO LUX HG01089 Instructions D'utilisation Et Consignes De Sécurité page 17

Insert the screw clamp
the screw clamp
screw (Fig. B).
3
Now place the screw clamp
ness and secure the screw clamp
clockwise (Fig. C).
Insert the articulated arm
and secure by tightening the wing bolt
1
Verify the articulated arm
Using the product
Plug the mains plug of the product into a properly installed
socket.
Move the ON / OFF switch
product on.
Move the ON / OFF switch into the 0 position to switch the
product off.
Adjusting the product
Never use force when adjusting the product.
The product can be adjusted in different ways:
· The lamp head is pivot-mounted inside the ball joint
· After loosening the locking screw
lamp head up or down. Tighten the locking screw
adjusting the light to the desired position.
· The individual parts of the articulated arm
by the joints
5
Using the magnifier
Lift the cover
10
Focus the object you wish to view by changing the distance to the
object and the distance between your eyes and the magnifier.
IMPORTANT: Keep the cover
is not in use. Please note, an open magnifier always poses a
fire hazard as light rays bundled by the magnifier can gener-
ate concentrated heat or a fire.
into the bracket
2
into the bracket
2
onto a table top ≤ 6 cm in thick-
2
into the round hole on the bracket
4
is firmly tightened in the bracket
4
into the I position to switch the
9
.
to use the magnifier.
10
(Fig. A). Secure
1
using the locking
1
by turning the screw
2
clockwise (Fig. D).
6
you can adjust the
7
can be moved
4
closed when the magnifier
.
1
(Fig. E).
8
after
7
GB/IE 17