Parkside PBH 1050 D4 Mode D'emploi page 31

˜ Selecting rotational speed
NOTE
The set speed is only reached in continuous
u
operation.
Rotate the speed selection wheel
o
the rotational speed from level 1 (low) to level
6 (high). The required speed depends on the
material to be processed.
˜ Troubleshooting
Problem Possible
cause
The product The motor is
does not defective.
work.
The Excessive
performance pressure on
the product.
of the
product is
poor.
The drill
chuck grease
is used up.
˜ Cleaning and maintenance
m WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use.
˜ Cleaning
NOTE
u
to select
[ 7 ]
u
u
Solution
u
Have the
product
repaired by
o
a qualified
specialist.
o
Apply
appropriate
pressure to the
product.
o
Lightly grease
the SDS-Plus
tool holder
[ ]
˜ Maintenance
with drill chuck
grease.
o
o
Do not use chemical, alkaline, abrasive or
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help
ensure safe use and prolong the life of the
product.
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The air vents must always be clear.
Clean the SDS-Plus tool holder
Lightly grease the SDS-Plus tool holder with
drill chuck grease .
[ ]
If replacement of the mains connection cable
is necessary, this must be carried out by the
manufacturer or his representative in order to
avoid safety hazards.
Check the product and accessories (e.g.
tools) for wear and damage before and
after each use. Replace them with new
ones if necessary. Observe the technical
requirements (see "Technical data").
Greasing: Lightly grease the SDS-Plus tool
holder with drill chuck grease
[ ]
regularly.
[ ]
.
[ ]
GB/IE 31