Parkside PBH 1050 D4 Mode D'emploi page 27

Use the power tool, accessories
g)
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation.
Keep handles and grasping surfaces
h)
dry, clean and free from oil and
grease. Slippery handles and grasping
surfaces do not allow for safe handling and
control of the tool in unexpected situations.
Service
Have your power tool serviced by
a)
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
NOTE
This product produces an electromagnetic
u
field during operation! This field may under
some circumstances interfere with active or
passive medical implants! To reduce the risk
of serious or fatal injury, we recommend
persons with medical implants to consult
their doctor and the medical implant
manufacturer before operating this product!
˜ Hammer safety warnings
m WARNING!
Wear hearing protection! Exposure to
loud noise can lead to hearing loss.
Wear a dust mask.
m WARNING!
Drilling and chiseling operations may deal
u
with materials which can produce harmful
or toxic dust. It presents a health hazard for
the person operating the power tool and
anyone else in the vicinity.
Ensure that you are not likely to hit power,
u
gas or water supply lines when you are
working with the power tool. If necessary,
check with a service line detector before
you start to cut or drill into a surface.
Safety instructions for all operations
Wear ear protectors. Exposure to noise
can cause hearing loss.
Use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
Hold the power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory or fasteners may contact
hidden wiring. Cutting accessory or
fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety instructions when using long drill
bits with rotary hammers
Always start drilling at low speed
and with the bit tip in contact with
the workpiece. At higher speeds, the bit
is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in
personal injury.
Apply pressure only in direct line
with the bit and do not apply
excessive pressure. Bits can bend,
causing breakage or loss of control, resulting
in personal injury.
GB/IE 27