Parkside PBH 1050 D4 Mode D'emploi page 30

NOTE
A damaged dust protection cap
u
be replaced immediately. Contact a
customer service workshop.
˜ Fitting an SDS tool
1. Grease the SDS-Plus tool holder
with drill chuck grease
the tool.
2. Insert the tool rotatingly into the SDS-Plus tool
holder until it clicks into place.
[ ]
3. Check that the tool is properly locked by
pulling it. The system has radial play because
of the design.
˜ Removing an SDS tool
Pull the locking collar
o
remove the tool.
˜ Selecting operating mode
Press and hold the release button
o
mode selection knob
selection knob so that the arrow mark points
to the corresponding symbol.
Symbol Operating mode
Drilling
Hammer drilling
Chiselling
Adjusting chisel position
Adjusting chisel position
In order to rotate the insertion tool to the required
position for chiselling, proceed as follows:
1. Turn the mode selection knob
(adjusting chisel position).
30 GB/IE
must
[ ]
slightly
[ ]
before inserting
[ ]
backwards to
[ ]
on the
8 ] [
. Turn the mode
9 ] [
to
9 ] [
2. Turn the insertion tool in the SDS-Plus tool
holder into the required position.
[ ]
3. Turn the mode selection knob
(chiselling).
˜ Setting the rotation direction
NOTE
Operate the rotation direction switch
u
only when the product is at a standstill.
Use the rotation direction switch to change
o
the direction of rotation of the power tool. This
is not possible while the on/off switch
pressed in.
Clockwise: Push the rotation direction switch
o
to the left as far as the stop.
Anti-clockwise: Push the rotation direction
o
switch to the right as far as the stop.
˜ Switching on/off
Insert the mains plug
o
The LED lights up to indicate that the
6 ] [
product is ready for use.
Switching on
Press the on/off switch
o
Do not switch the power tool on unless you
o
plan to use it, to save energy.
Switching off
Release the on/off switch
o
At low temperatures, the power tool will only
o
reach its full hammer performance/strike
power after a certain time.
Continuous operation
Press the on/off switch
o
press the lock button
switch.
To cancel continuous operation, press the on/
o
off switch and release it.
[ 3 ]
to
[ 9 ]
[ 2 ]
is
[ 3 ]
into a socket-outlet.
[ 5 ]
.
[ 3 ]
.
3 ] [
. At the same time,
[ 3 ]
to lock the on/off
[ 4 ]