Metabo SC 60 Notice Originale page 8

17026985_0310 SC 60.book Seite 8 Mittwoch, 24. Februar 2010 2:46 14
ENGLISCH
ENG
wash them with clean water and seek medical
treatment immediately!
Do not recharge a fully charged battery pack!
Overcharging damages and shortens the lifespan
of the battery pack!
Only use the charger indoors.
Protect the charger from moisture.
Children should be supervised to ensure that they
do not play with the tool.
Keep children away from the battery charger and
the working area!
Keep your battery charger out of reach of children!
Pull out the mains plug immediately if the battery
charger starts to smoke or flames emerge!
Do not insert objects into the ventilation slots on the
battery charger - there is a danger of electric
shocks and short circuits!
Do not use faulty battery packs.
5 Overview
See page 3.
1 Battery pack (not in scope of delivery)
2 Sliding seat
3 Operation display
4 Warning display
6 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with
your power supply.
Before commissioning the charger,
ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
6.1 Self-test
Insert mains supply plug.
The warning display (4) and the operating
indicator (3) light up in succession for approx.
1 second.
8
7 Use
7.1 Charging battery pack
Push the battery pack completely to the stop on
the sliding seat (2).
A battery pack that is new or has not been used for
some time only reaches full capacity after being
charged and discharged several times.
The operating indicator (3) flashes.
7.2 Conservation charge
Once the charging process has finished, the
battery charger automatically switches to
conservation mode.
The battery pack can remain in the battery charger
and is therefore always ready for use.
The operating indicator (3) lights up continuously.
8 Fault
8.1 Warning display (4) lights up
continuously
Battery pack is not charged. Excessive/Insufficient
temperature. When the temperature of the battery
pack is between 0 °C and 50 °C, the charging
process begins automatically.
8.2 Warning display (4) flashes
• Battery pack is defective. Remove the battery
pack immediately from the charger.
• The battery pack was not pushed correctly onto
the sliding seat (2). See section 7.1.
9 Repairs
Repairs to the charger must only be carried out by
qualified electricians.