Télécharger Imprimer la page

SilverCrest 442213 2304 Instructions D'utilisation Et Consignes De Sécurité page 33

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
protective gloves at all times if
such an event occurs.
This product features a built-in
rechargeable battery which
cannot be replaced by the user.
The rechargeable battery must
be removed or replaced by the
manufacturer or their service
centre or a similarly qualified
person to avoid hazards. When
disposing of the product, you must
indicate this product contains a
rechargeable battery.
Initial use
Set up suction station with
charging dock
Set up the suction station
and connect the power cable. The operating
control light
flashes in red.
21
Note: Keep 0.5 m from the left/right and 1.5 m
from the front clear of other objects.
Note: The area around the suction station
must not have mirrors or other highly reflective
objects within 15 cm of the floor. If necessary,
cover these.
CAUTION! Keep the suction station
direct sunlight.
CAUTION! Change the position of the suction
station
as little as possible.
14
Open the cover
and insert the dust bag
22
Close the cover
again. The operating control
22
light
flashes slowly, then the suction station
21
enters standby mode.
14
flat against a wall
14
14
out of
14
.
16
Charging the product
Fully charge the product before using it for the
first time.
It takes approx. 6 to 7 hours to charge.
Place the robot vacuum cleaner in front of the
suction station
, then connect it to the charg-
14
ing socket
.
19
Note: During the charging process, the oper-
ating control light
21
If the robot vacuum cleaner is fully charged
then this lights up in green and goes out after
some time.
Note: During everyday use of the product, make
sure that the charging sockets
If they are not, this could impair the charging
process.
flashes slowly in orange.
,
are clean.
13
19
GB/IE
33

Publicité

loading