PLAYTIVE 425415 2301 Notice D'utilisation page 12

• Check the product for damage and wear be-
fore each use. The product may only be used
in good order and condition!
• Warning. The toy creates flashes of light that
may trigger epilepsy in sensitive persons.
Battery warning notices!
• Remove the batteries when they are flat, or if the
product is not in use for an extended period.
• Do not use different types or brands of battery
or new and used batteries together or batter-
ies with different capacities as these can leak
and cause damage.
• Ensure the polarity (+/-) is correct when insert-
ing the batteries.
• Replace all batteries at the same time and
dispose of the old batteries as prescribed.
• Warning! Batteries must not be charged or re-
activated by other means, taken apart, thrown
into fire or short-circuited.
• Always keep batteries out of reach of children.
• Do not use rechargeable batteries!
• Cleaning and maintenance must not be car-
ried out by children without supervision.
• Clean the battery and device contacts as
needed and before inserting.
• Do not expose the batteries to extreme condi-
tions (e.g. radiators or direct sunlight). Other-
wise there is an increased risk of leakage.
• Warning. This product contains a coin battery
(button cell with lithium). If swallowed, a coin
battery can cause internal chemical burn injuries.
• Warning. Dispose of used batteries imme-
diately. Keep new and used batteries out
of the reach of children. Seek medical help
immediately if you suspect that batteries have
been swallowed or ingested.
Danger!
• Handle damaged or leaking batteries with ex-
treme caution and dispose of them properly as
soon as possible. Wear gloves when doing so.
• If you come into contact with battery acid,
wash the affected area with soap and water. If
battery acid gets in your eye, rinse it with water
and seek medical attention immediately!
• The connection terminals must not be short-cir-
cuited.
12 GB/IE
Inserting/replacing batteries
(fig. B/fig. D/fig. E)
WARNING! Comply with the following
instructions in order to prevent mechani-
cal and electrical damage.
For inserting and replacing the batteries (4b)/
(17) proceed as shown in fig. B/fig. D/fig. E.
Note: You will need a suitable screwdriver (not
contained in delivery).
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
The batteries must be located entirely inside the
battery compartment.
Assembly
To assemble the product, follow the individual
steps as shown in Figs. F–H.
Assembly variants
Assembly variants can be found in the enclosed
overview.
Note: assembly variants with multiple, con-
secutive curved parts can potentially derail the
vehicles!
Clean the tracks with a damp cloth before using
them for the first time!
Use
Safari vehicle (Fig. C)
1. Slide the switch (7a) to 'ON' to turn the
product on.
2. Press the front button (7b) to drive forwards.
3. Press the middle button (7c) to stop the safari
vehicle.
4. Press the back button (7d) to drive backwards.
Warning! The safari vehicle is not intended to
drive backwards on bridges or inclines.
5. Slide the switch (7a) to 'OFF' to turn the
product off.
Volcano (Fig. I)
1. Pull the seal (3b) of the water tank out of the
volcano (3).
2. Use the dropper (15) to fill the water tank with
liquid.