Bosch 4 Serie Manuel D'utilisation page 23

Correcting tool adjustment
▶ Never operate a tool that touches the
bowl.
Requirements
¡ The mains plug is not inserted.
¡ The swivel arm is open.
¡ The professional beating whisk is inser-
ted.
¡ The bowl has been inserted.
Hold the beating whisk at the bottom
1.
with one hand and release the lock nut
clockwise using a spanner wrench.
→ Fig. 4
To change the setting, turn the tool in the
2.
desired direction.
→ Fig. 5
Optimum setting
Turn clockwise
Turn anticlockwise Lower tool
Press the release button and push the
3.
swivel arm down until it engages.
Check the setting.
4.
Press the release button and raise the
5.
swivel arm until it engages.
Hold the beating whisk at the bottom
6.
with one hand and tighten the lock nut
anticlockwise using a spanner wrench.
Parked position
After the appliance has switched off, the
drives will continue moving for a few
seconds until the correct parked position is
reached.
Note: The swivel arm will only open or close
with the inserted tool when the drive is loc-
ated in the correct parked position.
Tip: You can easily adjust an incorrect
parking position yourself.
→ "Troubleshooting", Page 26
Distance to the
bowl ap-
prox. 3 mm
Lift tool
Safety systems
Start lock-out
Start lock-out prevents your appliance from
being switched on accidentally.
The appliance can only be switched on and
operated if the swivel arm is correctly en-
gaged in the work position.
For some models:
The appliance can only be switched on and
operated if one of the following conditions
is satisfied:
¡ The swivel arm is engaged in horizontal
position and the bowl or ice cream
maker is inserted.
¡ The swivel arm is engaged in vertical po-
sition and the protective drive cover or
an assembled accessory is secured cor-
rectly.
Restart lock-out
Restart lock-out prevents your appliance
from automatically restarting processing
after a power failure.
The appliance is switched on again after a
power failure. Processing cannot start
again until the rotary switch has been set to
⁠ .
Overload protection
The overload protection system prevents
the motor and other components from be-
ing damaged through being overloaded.
Operation
Operation
Operation
Setting up appliance
Place the appliance on a stable, level,
1.
clean and flat work surface.
Adjust the power cable to the required
2.
length.
– Pull the power cable out to the re-
quired length and slowly let go.
– To roll the cable up again, briefly pull
on the cable and let it wind up.
Note: Do not push the cable into the
cable rewinder by hand. If the cable
jams, pull right out and let it wind up
again.
Do not insert the mains plug.
3.
Operation en
23