UNITED OFFICE UAVS 450 A1 Mode D'emploi Et Consignes De Sécurité page 11

♦ Insert paper into the middle of the cutter opening
portrait format (see fig. 3). The appliance starts automatically and switches
itself off automatically if no further paper is inserted.
Fig. 3
Note
► Regularly remove any residue left in the cutting blades with a suitable object
(e.g. brush or tweezers). Ensure that the appliance is unplugged before
doing this.
Clearing a material blockage
Note
► In the event of a material jam, the appliance starts a short automatic reverse
run in order to release the material from the cutting blades so you can
remove it from the cutter opening
If this is not enough to remove the material being shredded, proceed as
described below.
♦ Press the REV button
The appliance now goes into reverse and the material is ejected.
♦ Alternatively, press the FWD button
is jammed. The appliance is now in forwards operation and the material that
is being shredded is pulled in again.
♦ Press the AUTO button
Turning the appliance off
Note
► We recommend that you switch off the appliance and let it cool down for
about 10 minutes after 30 minutes of operation to prevent overheating.
♦ Press the AUTO button
LED
♦ Move the On/Off switch
switch the appliance off.
GB │ IE
│
■ 8
r
(reverse) if the paper being shredded is jammed.
t
as soon as the jammed paper is cleared.
t
to switch the appliance into standby mode. The
t
goes out.
3
on the rear of the appliance into position
4
from above and in
4.
e
(forward) if the paper being shredded
O
to
UAVS 450 A1