Würth HKS 28-A Traduction Des Instructions De Service D'origine page 19

HKS 28 A.book Seite 19 Dienstag, 5. September 2017 2:51 14
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EG on waste electrical
and electronic equipment and its in-
corporation into national law, power tools that are
no longer suitable for use must be separately collect-
ed and sent for recovery in an environmental-friend-
ly manner.
Battery packs/batteries:
Do not dispose of battery packs/batteries into
household waste, water or fire. Battery packs/bat-
teries must be collected, recycled or disposed of in
an environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled accord-
ing to the directive 91/157/EG.
Transporting Lithium
Batteries
Lithium-ion batteries are subject to the Dangerous
Goods Legislation requirements.
Transportation of those batteries has to be done in
accordance with local, national and international
provisions and regulations.
The user can transport the batteries by road without
further requirements.
Commercial transport of Lithium-Ion batteries by
third parties is subject to Dangerous Goods regula-
tions. Transport preparation and transport are
exclusively to be carried out by appropriately
trained persons and the process has to be accompa-
nied by corresponding experts.
When transporting batteries:
Ensure that battery contact terminals are protected
and insulated to prevent short circuit.
Ensure that battery pack is secured against move-
ment within packaging.
Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice.
Warranty
For this Würth tool, we provide a warranty in ac-
cordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by in-
voice or delivery note). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be accepted only when the machine is
presented undisassembled to a Würth branch office,
your Würth sales representative or a customer serv-
ice agent for Würth pessure air and power tools.
Noise/Vibration Information
Measured values determined
EN 60 745.
Typically the A-weighted noise levels of the machine
are:
Sound pressure level: 91 dB (A);
Sound power level: 102 dB (A).
Wear hearing protection!
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60 745:
Vibrational emission value a
2
tainty K = 1.5 m/s
The vibration emission level given in this information
sheet has been measured in accordance with a
standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of the vibrational
impact.
The declared vibration emission level represents the
main applications of the power tool. However if the
power tool is used for other applications, with differ-
ent accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the vibrational impact over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the
exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: Main-
tain the power tool and the accessories, keep the
hands warm, organisation of work patterns.
according to
2
< 2.5 m/s , uncer-
h
19