Publicité
Les langues disponibles
Les langues disponibles
START- UP
The controls required to start and run the rototiller are located on the engine and are marked "choke" and
"Throttle". A more detailed description of engine operation and all related precautions and procedures can
be found in the engine manufacturer's manual that accompanies each tiller.
COLD STARTS
1. Move choke lever to full choke position.
2. Move throttle lever to "start".
3. Pull starting rope out slowly one time and allow to return normally.
4. Pull starting rope out rapidly, and allow rope to return normally.
When engine starts, gradually move choke lever to "no choke" position and increase throttle speed.
CAUTION
PLEASE DO NOT START YOUR TILLER UNTIL YOU HAVE READ THE MANUAL THAT CAME WITH YOUR
ENGINE, AND THE SECTIONS IN THIS MANUAL ENTITLED CONTROLS, ADJUSTMENTS AND SAFETY. IF
YOU HAVE READ THESE, FOLLOW THE STEPS BELOW TO START YOUR TILLER, ALWAYS PERFORM THIS
PRE-START CHECKLIST BEFORE STARTING THE ENGINE
WARNING
GASOLINE IS HIGHLY FLAMMABLE AND MUST BE HANDLED WITH CARE. NEVER FIL THE TANK WHEN
THE ENGINE IS HOT OR RUNNING, ALWAYS MOVE OUTDOORS TO FILL THE TANK
WHEELS MUST ALWAYS BE LOCKED IN THE TILLING POSITION WHEN ENGINE IS RUNNING. DO NOT
OPERATE THE TILLER WITH THE WHEEL LOCKOUTS UNLOCKED. ALWAYS SET THE WHEELS IN TILLING
POSITION BEFORE STARTING ENGINE.
ALWAYS PUT THE DEPTH REGULATOR LEVER IN THE TRANSPORT POSITION BEFORE STARTING
ENGINE. TINES SHOULD CLEAR THE GROUND.
IMPORTANT
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING
ENGINE
DANGER
ALWAYS KEEP HANDS AND FEET CLEAR OF ROTATING MACHINE PARTS
RESTARTING A WARM ENGINE
Restarting an engine that is already warm from previous running does not normally require use of the choke.
1. Move throttle lever to "start" position.
2. Pull starting rope out rapidly until engine starts. Allow rope to return normally. Repeat until engine starts.
3. Adjust throttle speed to "high" for best tiller action.
IDLE SPEED
Use the "low" position on the throttle lever to reduce stress on the engine when tilling is not being
performed. Lowering the engine speed to "idle" will help extend the life of the motor, as well as conserve fuel
and reduce the noise level of the equipment.
OPERATING SPEED
For normal tilling, set the throttle lever to "fast".
SHUTTING DOWN
To stop the engine at any time, turn engine ON/OFF switch to the off position. To stop wheels and tines at
any time, release drive safety control levers to neutral position.
BE-BRTXXX USER MANUAL
9
Publicité
