Publicité
Les langues disponibles
Les langues disponibles
TILLING
1. Adjust the depth regulator lever to desired tilling depth.
NOTE: Raise depth regulator lever up one hole at a time, testing tiller operation after each raise. Raising
depth regulator lever too high can result in loss of control of tiller!
2. Move the throttle control to fast.
3. Place the tiller in forward by pushing down on the drive safety control lever (FORWARD)--this will engage
the wheels and tines.
NOTE: You can slow the tiller's forward advance at any time by putting slight downward pressure on the
handlebars. You can stop the tiller by releasing the drive safety control levers to the neutral position.
WARNING
Temperature of muffler and near by areas may exceed 150° F, avoid these areas.
Do not move choke control to choke to stop engine. Backfire or engine damage may occur.
To stop wheels and tines at any time, release drive safety control levers to neutral position.
Always release drive safety control levers to neutral position before adjusting the depth of the regulator
lever
DANGER
Engine and surrounding parts become extremely hot during normal use and will cause serious burn
injuries if touched before the engine has cooled.
Allow engine cool completely before touching these hot surfaces
IMPORTANT
Practice operating the controls and tiller with tines out of ground before beginning to till. It is important
that you know how to use the tiller property, keep control at all times, stop the tines and wheels from
turning, and stop the engine if necessary, if you do not know how to do these things, read the controls,
adjustments and safety sections before proceeding
DRIVE SAFETY CONTROL LEVERS
FORWARD LEVER
Engages wheels and tines into forward.
Pushing down the drive safety control lever (FORWARD) toward the handlebar engages the wheels and
tines. Releasing the lever stops the wheels and tines and brings the tiller to a complete stop.
CAUTION
Do not operate both "Forward" and "Reverse" drive safety control levers at the same time.
This information is provided here only to introduce the controls, do not start the engine at this time.
• As a safety precaution, the drive safety control levers will not lock in the forward or reverse position.
• As a safety precaution, the reverse drive safety control lever will not lock in reverse.
• To stop the wheels and tines at any time, release the drive safety control levers or release the reverse
handle.
• Do not operate both the reverse and forward drive safety control levers at the same time
10
BE-BRTXXX USER MANUAL
Engages wheels and tines into forward.
Pushing down the drive safety control
lever(FORWARD) toward the handlebar
engages the wheels and tines. Releasing
the lever stops the wheels and tines and
brings the tiller to a complete stop.
REVERSE LEVER
Publicité
